Product Manual
6
Installation
Allow at least 1 inch of clearance all around the case for cooling. The best mounting congu-
ration is to mount the unit on a vertical surface oriented as shown. Use #10 screws of the
appropriate type for the mounting surface to securely mount the unit.
There is 1500 volts of isolation between the input and output, and the input and case. There is
500 volts (1500V for 48V Output) of isolation between the output and case. Therefore, the unit
may be mounted on any surface without fear of electrolysis or ground fault.
POWER CONNECTION
The unit is supplied with power leads 1 meter long. This should normally be adequate to
connect to a source of power. If you must extend the power leads, be sure to use at least a
good quality (typeTEW) AWG12 wire. The wire colours are:
All connections should be made inside an appropriate junction box. Refer to the specications
table for the correct sizing of the circuit breaker in the distribution panel.
A ground stud is provided to bond the chassis to local ground to reduce or eliminate EMI.
Red - Positive Black- Negative
INPUT
FUSE
TO
REMOTE
OUTPUT TERMINAL
ON/OFF
INPUT POWER