SMP100 Manual

3
WARNING
Installation should be performed by qualied personnel only. SolarMax has no user-
serviceable parts. To reduce the risk of electric shock, do not perform any installation (or
servicing) other than specied in these instructions. See our RMA and warranty policies
should servicing be required.
1. Do not expose the SolarMax charge controller to rain, snow, spray, or dust. To prevent
overheating, do not obstruct any ventilation openings.
2. Use of an attachment not recommended or sold by Analytic Systems may result in a risk
of re, electric shock, or injury to persons.
3. Do not disassemble the SolarMax charge controller; consult the manufacturer rst, or
take it to a qualied serviceman when service or repair is required. Incorrect reassembly
may result in a risk of electric shock or re.
4. To reduce risk of electric shock, disconnect from solar panel before attempting any
maintenance or cleaning.
5. Never place the SolarMax charge controller directly above a battery; gases from battery
will corrode and damage it.
6. Never allow battery acid to drip on the SolarMax charge controller, especially when
checking the specic gravity of the battery or lling battery with distilled water.
Always isolate the SolarMax charge controller. Connect and disconnect the DC output
connections only after disconnecting the solar panels from the SolarMax charge controller.
Important Safety Instructions