Product Manual

1514
European Union Mains
Brown
AC Hot / Phase 1
Blue
AC Neutral / Phase 2
Green/Yellow
Ground
NA Mains
Black
AC Hot
White
AC Neutral
Green
Ground
Pin Polarity
Pin A AC Live/Hot
Pin B AC Neutral
Pin C AC Ground
1050M/1550M/1050MW/1550MW
M-series and MW-series BCA and PWS units are equipped with a 3-pin Amphenol circular
MIL-Spec connector to serve as an AC Input Connection. See Specications for more
information regarding suitable mating connectors. This connector’s wiring pin-out can be
found on the front panel label and is as follows:
AC Input Connection
The AC Input connection is intended for connection to the AC power source that is powering
the battery charger or power supply. All 1050 and 1550 units feature Power Factor Correction
technology on the input and can operate from any AC input voltage from 90-264 VAC.
Some units may require wiring to this connection. To determine suitable wiring, the rated
input voltage and current values can be found on the unit label located on the XXXX panel. For
more information, regarding input power specications, see the Specications section.
1050/1550/1050W/1550W
Regular and W-series BCA and PWS units are equipped with a 1.0m/3.0ft power cord ending
in a NEMA 5-20 plug connector (for North American models) or a CEE7/7 plug connector (for
European models) to serve as an AC Input Connection.
To hard wire this connection a source of power, cut the plug off the wire, and strip the wires
inside as necessary. The wire colors are as follows: