IPSi3600 Manual

6
Operation
Controls and Indicators
Push the On/Off control to to energize the outputs. The switch will glow to indicate the
presence of AC power at the receptacles.
The IPSi3600 Inverter has 8 LED indicators, a
microUSB port and a Push On / Push Off power
switch. The power switch will glow to indicate
the presence of AC power at the receptacles.
The microUSB port is used to connect the
IPSi Inverter to a laptop computer running the
PowerWizard software and can be used to
update the rmware, to adjust the low and
high voltage alarm setpoints, to choose the
output frequency (50 or 60 Hz) and to ne tune
the output voltage +/- 10% in 1 VAC steps.
OUTPUT CONNECTIONS
Two standard circuit breaker protected 20 Amp AC receptacles are provided for connection.
In addition a 30 amp, 250V rated CSA/UL approved terminal block is provided for wiring to a
distribution panel. This terminal block is NOT circuit breaker protected so each device wired to
the distribution panel must have its own breaker. Ensure that the total average load of all the
devices does not exceed the continuous current rating of the unit.
CAUTION: Do not apply AC voltage to the outlets. Damage caused by this action will not be
covered under warranty.
DISCONNECTION
If you disconnect the unit to remove it for service or storage, turn the power switch on for at
least one minute after it has been disconnected to discharge the storage capacitors.
Note: The microUSB port and PowerWizard software are not currently implemented for the
IPSi Inverters, but are expected to be available in mid 2016.