Product Manual

Connection

POL

TEMP

DEV

SVC

FLT

LO V

BAT

INSTALLATION INDICATORS

AC PRESENT BATTERY POLARITY REVERSED

POL

TEMP

DEV

SVC

FLT

LO V

BAT

1. Connect the charger to the batteries before connecting to the AC mains.

2. As you complete the connection to each battery, check the ‘REV’ indicator light on the

charger front panel. If it glows RED, the battery is connected in reverse. Stop and reverse

the connections to the battery (Red should go to Positive and Black should go to Nega-

tive). After all battery banks are connected, double check that the REV indicator light is

still OFF.

3. Connect the charger to the AC mains. The AC LED should illuminate. This indicates that

the charger is receiving power from the AC mains and that the internal power supply is

running. Turn the charger OFF again.

Press the Power button on the front panel to turn the

charger ON. The Power button will illuminate once

the charger has turned on. Once the startup routine is

complete, enter Setup mode by pressing and holding

the PRG button for 3 seconds until you hear a one

second beep and the Charge LED starts blinking

Setup

Battery Type

Each press of the Equalize (EQU) button will advance the battery selection. The three LED’s on

the top will indicate Flooded, AGM and Gel when lit. The fourth press will light all three LED’s

if there is a valid custom conguration.

Flooded – The lead–acid battery was invented in 1859 by French physicist Gaston Planté and

is the oldest type of rechargeable battery. Despite having a very low energy-to-weight ratio

and a low energy-to-volume ratio, its ability to supply high surge currents means that the cells

have a relatively large power-to-weight ratio. These features, along with their low cost, make