Product Manual

15
Power Supply Mode
The IBC320 charger can be switched to Power Supply Mode at any time by pressing and
holding the Power button for 3 seconds until you hear 2 beeps. This changes the operation of
the charger in the following ways.
1. The outputs will turn on regardless of whether a battery is detected or not.
2. The Output Power indicator LEDs will all blink any time the output current reaches 100%.
3. The output voltage is xed at the oat voltage for the battery type selected during Setup
(in case there is a battery connected).
4. The EOC switch and 2-3 Stage switch have no function.
5. There is no Equalize mode.
6. By use of the Power Wizard PC software, it is possible to customize the output voltage in
Power Supply mode within the working range of the unit. To do this, go through the setup
routine and select the Custom Battery prole. Then using the Power Wizard software,
connect to the charger and program the oat voltage for the Custom Prole to any volt-
age between 12.0 to 15.0 volts (scale appropriately for other charger output voltages).
The charger will remain in Power Supply mode until switched back to Charger mode by press-
ing and holding the Power button for 3 seconds again until you hear 1 beep
POWER SUPPLY INDICATORS
BLINKING
CURRENT < 10% CURRENT 11 - 39%
POL
AC
TEMP
DEV
SVC
FLT
LO V
BAT
EQ
PS
CH
25 50 75
CURRENT > 40 - 59%
CURRENT > 85%
CURRENT 60 - 84%
CURRENT = 100%
POL
AC
TEMP
DEV
SVC
FLT
LO V
BAT
EQ
PS
CH
25 50 75
POL
POL
AC
AC
TEMP
TEMP
DEV
DEV
SVC
SVC
FLT
FLT
LO V
LO V
BAT
BAT
EQ
PS
EQ
PS
CH
CH
25
25
50
50
75
75
POL
POL
AC
AC
TEMP
TEMP
DEV
DEV
SVC
SVC
FLT
FLT
LO V
LO V
BAT
BAT
EQ
PS
EQ
PS
CH
CH
25
25
50
50
75
75