Product Manual

6
** Actual startup is at 22, 42, or 67Vdc Input, depending on model
* This is Analytic Systems’ suggested range. Please consult your battery manufacturer for their recommendations.
* Specications subjects to change without notice.
Installation
MOUNTING
Mount the unit in a DRY location. Allow at least 4 inches of clearance around the heat sink
ns for adequate cooling.
POWER CONNECTION
The unit is supplied with power leads about 3 feet long. This should normally be adequate to
connect to a source of power. If you must extend the power leads, be sure to use at least a
good quality (typeTEW) AWG 8 gauge wire. The wire colours are:
Red - Positive Black- Negative
Designed and manufactured by: ANALYTIC SYSTEMS WARE (1993) LTD.
8128 River Way
Delta, BC V4G 1K5 Canada
p. 604.946.9981 f. 604.946.9983
tf. 800.668.3884 US/Canada
www.analyticsystems.com [e-mail] Revised August 2014
General
Battery Banks 1 or 2
Stages 2 or 3
Switching Frequency 60 ± 2 KHz
Idle Power < 10 Watts
Noise on Input < 50 milli-Volts
Noise on Output < 50 milli-Volts
Transient Response < 2V for 50% Surge (Output Amps/2)
Efciency > 75 % @ maximum output
Temp. Range -25 to 40 deg. C @ maximum output
Isolation
Input-Output & Input-Case 1500 Vdc (500 Vdc @ 24 V In),
Output-Case 500 VDC (1500Vdc @ 48 V Out)
Dimensions 14.5 x 10 x 4 in / 37 x 25 x 10 cm
Clearance 1 Inch (2.5 cm) all around
Material Marine Grade Aluminum
Finish Black Powder Epoxy
Fastenings 18-8 Stainless
Weight 7.2 lb / 3.3 kg