User Manual

32
7.2.6 Output management
A short summary of each output sengs
appears on the main page. You can see the
number of outputs, their resoluon, rate and
HDCP status.
Select an output to adjust by either clicking on
it from the column on the le, or clicking the
conguraon cog icon for that output.
Once the individual output setup page is
opened, you have access to:
 choose your rate generaon mode,
internal (free-running within the unit) or
Framelock by choosing an input as a reference
input,
- FORMAT: choose the output resoluon
format,
- RATE: choose the signal ming standards, if
the mode is set to internal
- STATUS: the status menu will show you the current output status,
- APPLY: click on this buon to apply the new format/rate,
- PLUG STATUS: indicates the status of the aached monitor and conrms connecvity,
- TYPE: you can choose the type of output synchronizaon on the analog plug, for example RGsB for sync on
green, or RGBHV for separate H and V sync wires,
- FORCE DVI MODE: select this box to force the output to DVI mode instead of the default HDMI autosense
mode. When in DVI mode, no embedded audio will be transmied,
- PATTERN: a selecon of paerns is available to test your output. These paerns will override any input
selecon that you might have.
You can choose from:
•  – turns the paern o
•  – displays grey bars
•  – displays color bars
• Grid – displays an 8x8 box grid paern
• SMPTE bars – displays the SMPTE color bar paern
•  – displays alternang black and white 1 pixel wide columns
• – displays a 0 to 100% gradient paern.
- FLICKER: choose the value of the icker lter to remove the icker eect on your interlaced output screen,
- GAMMA: increase or decrease the gamma of your output,
- HDCP: enable/disable and see the HDCP status,
- CENTERING: displays a 1 pixel wide doed line at the edge of the output (only available for computer
formats)
Depending on the output format chosen, only relevant sengs will appear.
Into the output secon, you will be able to manage your output resoluons, formats, sync types, test paerns,
etc. On the SETUP > OUTPUT TAB, the following screen will appear:
