User guide
SMX System MultiMatrix Switcher • Operation 24
4. Press and release the desired input button (1-10) to select the plane preset address to
save the current configuration to. The Address, Preset, and Enter buttons flash red.
NOTE: A preset can be saved to any lit or unlit input button (1 through 10). Only
presets with lit buttons can be recalled. When a preset is saved to a lit
button (already containing a preset), the stored data is overwritten with the
new data. Only one plane preset can be saved to an address at a time.
5. Press and release the Enter button. The plane preset is saved or recalled.
Step 4.
Press and release the desired (unlit or lit) input button 1-10
(here preset 3). The selected button flashes red.
Enter button also blinks (red).
ENTER
Step 5.
Press the Enter button to
save or recall the preset.
All buttons extinguish.
C O N T R O L
PRESET
ESCVIEW
INPUTS
1
2
3 4
5
6 7 8
9
10
11 12
13 14 15 16
OUTPUTS
1
2
3 4
5
6 7 8
9
10
11 12 13 14 15 16
I/O PLANE SELECT
1
2
3 4
5
6 7 8
9
10
11 12 13 14 15
0
Step 3.
Press desired plane button (here plane 0).
Plane button lights green.
Buttons for any previously saved plane presets light red (here preset 7).
NOTE: To recall a plane preset, press and release the Preset button.
Select a plane, then press and release a lit preset button.
Figure 21. Saving or Recalling a Plane Preset — an Example
(Steps 3 through 5)
Setting RGB Delay (VGA and RGBHV Boards Only)
NOTE: This feature is applicable only for VGA and RGBHV boards and can not be set via
the front panel when the SMX is in lock modes 1 or 2.
1. Press the Esc button to clear all pending changes. The button flashes green once.
2. Select a VGA or RGBHV plane.
3. Press and hold View for 3 seconds. The selected plane button flashes green.
4. Select the output to delay. The button lights.
5. Using View (
<
) and Esc (
>
), adjust the time duration for the delay (up to 5 seconds
maximum). Each lit input button corresponds to a half-second delay.
NOTE: No input buttons lit signifies zero delay, 10 buttons lit signifies 5 seconds
delay.