User guide

SMX System MultiMatrix Switcher • Operation 15
Control Buttons
d Control selection buttons — These four buttons give direct
access to the enter (save), preset, view, and Esc (exit) controls.
Each button has a separate function.
NOTES: • See Configuring the Rear Panel RS-232/RS-422 Port on page 26 for
serial port configuration details.
• See Setting the Front Panel Locks (Executive Modes) on page 25 for
executive modes details.
Enter button — The Enter button flashes green when a change to an input or output
tie is pending, or red when a preset recall is pending. Pressing the flashing button saves
the change or recalls the preset, and the Enter button and any lit input and output
buttons extinguish (see Front Panel Operation on page 16).
Preset button — The Preset button gives access to recall or save up to 32 global presets
(using I/O buttons 1 through 16), and 10 plane presets (using input buttons 1 through
10). The button lights red when pressed. Upon recalling or saving the preset, the button
and all input and output buttons (lit red) are extinguished (see Front Panel Operation
on page 16 and Saving and Recalling I/O Presets on page 22).
NOTE: Global presets save and recall the configuration for all planes. Plane presets
save and recall the configurations for a specific plane without affecting the
other plane connections.
View (
<
) button — This button, when pressed and released, lights red and allows
quick viewing of existing input and output ties. When the button is lit, after selecting
a plane and an associated input, muted outputs flash and untied outputs light the
appropriate signal color (red, green, or amber). Tied outputs remain unlit.
NOTE: Use this button to decrease settings for RGB delay, input audio level, and
output audio volume. This button also mutes and unmutes outputs (see the
Muting or Unmuting a Video, Audio, or Video and Audio Output on
page 20).
Esc (
>) button — This button, when pressed, flashes green once and all lit control,
plane, input, and output buttons are extinguished.
NOTE: Use this button to increase the RGB delay, input audio level, and output
audio volume.
Also, when used in combination, the buttons have the following functions:
Control Button Combination Function
Enter Preset View Esc Selects the serial port configuration.
Preset View Esc Toggles between executive modes 2x and 0x.
View Esc Toggles between executive modes 2x and 1x
or initiates a system reset.
Power Indicator LEDs
e Power indicator LEDs — These two LEDs, labeled Main and I/O cards, light green
when power is applied to the unit. The LEDs light red when the main or redundant
power supply fails.
PRESET ENTER
ESC
VIEW