Owner manual

57
7.4.6 Logos and Frames management
On the Edit secon, you can have access to your 8 sll slots. Those slots can be lled by logos and frames.
To load the slots, go into the Setup secon and click on Logos menu.
Or into the Edit secon, under the logos tab, click on the Setup buon to access to the slot conguraon.
Choose the logo into your library to ll the slot. Other logos setups are available. (See chapter: 7.3.12 Logo
management)

Use only the live mode when all your pre-
sets are correctly done and ready to use. This
mode is for live use.
On the right, you will nd all your memorized
presets under the tab called “ MEMORIES ”.
A simple drag and drop on the screen will
load your preset into the screen (Program
or Preview).
You can at any me modify a memory by
clicking on the Setup shortcut on the right of
you preset memory.
LABEL: don’t forget that you can aect a
name to your memories.
If you want to change an input into your pre-
set into the live mode, simply use the le
source ribbon and drag and drop your input
into a layer.
Under each preset you have its size and its
duraon.
Remember that a preset saved into a screen
with a 1024x768 resoluon, will keep its size
into a screen of higher resoluon.
If you want the preset to be adapted to the
screen size, use the AUTOSCALE buon.
With this funcon enabled, all presets will be
automacally stretched to the right size to ll
the selected screen.
FILTER FEATURE: use the Filter feature to
load and take only some presets informaon.
Choose between: source, pos/size, trans-
parency, cropping, border, transions, ef-
fects, ming, speed, ying curves, Nave
background and ALL at the same me. Only
the selected feature will be load and take
with the preset. If you want to load the en-
re preset, please use ALL.
7.5 Live