Owner manual

48
7.3.16 Control management
In this menu, all specic sengs, which can not be sorted under the other menus,are listed.

The web interface loaded into the unit uses the IP conguraon.
Under INTERFACE, you can dene a new:
- IP address
- Netmask
- Gateway
- Port: Choose the port
- Protocol: Choose TCP (by default) or UDP
Choose DHCP if you want an automac IP address assignment.
Under the Web RCS feature, you can dene the communicaon Port. You also have an indicaon on the
number of connected devices.
Emergency presets:
The emergency presets allow you the recall quickly some Master Memo-
ries (see chapter: 7.5 Live / Master memories). You have the possibility
to have up to 4 emergency memories. Please enable the feature then
choose for each line a master memory which will be recalled in case of
problem.
By enabling the emergency memories, some new buons will appear
into the live edion:
If you click on A or B, it will recall automacally the MM1 MM2 MM3 or MM4 on the main
screen.

Click on start to launch an auto calibraon, in terms of colors, on your analog input/output chips. (See chap-
ter: 11. Maintenance and support)

Into this secon, you can erase individual sengs.
• Erase input sengs memory: All input sengs will return to their default value. This includes image, aspect,
user format and keying parameters.
• Erase preset memories: All preset memories will return to their default value.

Click on start to erase all sengs (except network and Web RCS parameters). The unit will reboot itself aer
the factory reset. Do not forget to refresh your Internet browser by using CTRL+F5. (Clean browser cache.)
