Owner manual

44
7.3.13 Monitoring management
The Monitoring output allows you to have a full Preview of your dierent outputs but also your sources.
In addion, you have access to a lot of status shortcuts directly on the screen like HDCP status, KEYING status,
FREEZE status etc.


 Choose the output format
 Choose the signal ming format
 You can choose the type of output synchronizaon on analog plug or digital plug
 Rename your output
Access the output status
A paern is available to test your output without any input selected
 Choose the value of the icker lter to disabled the icker eect on your screen (interlaced lines
eect)
 Increase or decrease the luminosity of your output
 Enable/disable and see the HDCP status
Depending on the output format chosen previously, all sengs might not appear.
Into the layout tab, you can choose one of the monitoring layouts. Simply click on the desired layout to auto-
macally see this layout appear on your monitoring screen.
A fullscreen mode is also available. Clicking on FULLSCREEN logo, allow you to select the source which will ll
the monitoring output.
Then you can choose to display or not the OSD on it.