Owner manual

37
7.3.9 Input management

- Enable/disable the HDCP communicaon feature
- Read the HDCP status, very useful to know if the input HDCP communicaon is acve or not.
Next is the IMAGE tab, where you can nd all sengs about the display of your input:

set up the luminosity level of your input
 set up the contrast level of your input
 set up the color level of your input (0:black and white, full: full color)
set up the hue phase of your NTSC signal.

 Displays a number on your input to quickly idenfy the source
 Enable test paern on the input. It allows you to start working without any plugged source.
Turn your input to black
Freeze/unfreeze your input
Set up to Hi-Z (default) or to a 75Ohm load your input.

Automac search of the right Clock and Phase of your input. In other words, it automacally
centers your input into the layer. There are a quick search and an advanced search.
 Set up manually the clock of your input
Set up manually the phase of your input

 Increase/decrease the Red/Green/Blue level of your input.