Owner manual

35
7.3.9 Input management
•  – displays color bars
• Grid – displays an 8x8 box grid paern
• SMPTE bars – displays the SMPTE color bar paern
•  – displays alternang black and white 1 pixel wide columns Centering – Displays a 1 pixel wide doed
line at the last pixel of the output
• Circle – displays a circle, no maer what the resoluon of the output is. This is useful for checking aspect rao and
geometry through your system.
•– displays a choice of color that lls the screen.
•  – displays a diagonal line paern which can be adjusted in size.
• – displays a 0 to 100% gradient paern
• Output ID – displays the number of the output as a numeral on the screen
•  – displays a crosshair which moves around the screen.
Choose the value of the icker lter to remove the icker eect on your interlaced output screen.
 Increase or decrease the gamma of your output.
 Adjusts the threshold of the coring /crispening adjustment point.
Enable/disable and see the HDCP status
 Enable/disable and see the opcal status
Depending on the output format chosen previously, all sengs might not appear.
Once your outputs are congured, you have now to congure the inputs connected to your SmartMatriX
Ultra. Under the inputs secon, you can view your inputs or by all plugs (acve and inacve).
7.3.9 Input management
In both cases, an AUTOSET ALL can be launched to set up automacally your inputs.
Once the AUTOSET ALL is done, you can check one by one your inputs and see if they were well detected
thanks to the input STATUS. The input STATUS is dened by a FORMAT and a SIZE. If that informaon is not
available, your input has not been well detected or set up.