Owner manual

13
4.2 Unpacking and inspecon
• 1 x 
• 1 x Power supply cord
• 1 x Ethernet cross cable (for device control)
• 1 x Web-based Remote Control Soware included and hosted on the device
• 1 x Rack mount kit
• 1 x User manual (PDF version)*
• 1 x Quick start guide*
* User manual and Quick start guide are also available on www.analogway.com
Before racking and plugging any inputs and outputs, it is advised to power on the unit. If you encounter any
issue, you must contact immediately your local distributor or dealer, or closest  technical support
oces (see chapter: 14. Contact informaon).
 The SmartMatriX Ultra can be used directly on a table; the unit is equipped with 4 handy
an-slip rubber feet.
 The SmartMatriX Ultra is compable with a 19” enclosure. Please follow the instrucons
below to install the device in a 19” rack.
CAUTION: The SmartMatriX Ultra weighs 41.89LBS (19Kg). Please provide appropriate support to the frame
during installaon. First, place ears on each side of the device (ref. 180514). Place the device in your rack.
Aach the device to the rack by using 2 screws through the ears (screws not included).
Addional support, such as the rear rack support or slide rails, is required. The SmartMatriX Ultra is equipped
with drill holes designed for compability with rack mount (ref: 180489). Use 4 screws M4x10 countersinck
on both sides of the unit. Adjust the size of the rail in order to ll your rack.
A lacing bar is provided with the rack mount kit (ref: 180489). Install it with the M4x10 screws according to
your cables posion.
Connect all of the cables to the device and aach them to the lacing bar with the help of e wraps.
IMPORTANT:
- The openings in the front and rear panels of the device are for cooling. Air ows from front to back. Do not
cover these openings to avoid cung air circulaon.
- The maximum ambient operang temperature should not exceed 40°C (104°F).
- The rack and all mounted equipment in it must be reliably grounded according to naonal and/or local
electrical standards.
4.2 
4.3 
Dismantling front handles of the device could invalidate warranty on aer-sales services of
your SmartMatriX Ultra. It is strongly advised to avoid using front handles as rests for your
SmartMatriX Ultra, they are designed for manipulaon purposes only.
If required, front handles of the device can be dismantled, but with cauon. The original screws removed
can be reintroduced to their locaon without handles in place. Substanal damages can occur, including
risk of electric shock from the main voltage. Only M4x12mm screws can be used. They are supplied with
the unit.
CAUTION!
Mounng using only the front
rack ears is sucient for xed
installaons. Addional support,
such as the rear rack support or
slide rails, is required for mobile
applicaons, and recommended
for all.