Owner manual
Setup assistant for adjusng all basic setups.
Manage your outputs and have access to every set-
ngs and parameters.
Congure your inputs connected to your
Load your Logos and Frames into the system.
Congure Logos and Frames selecons.
Congure the Condence monitor.
Congure the operator’s monitor including the re-
soluon and choice of layout, to show input or output preview
combinaons.
Access to all Analog Way maintenance services
(update, etc.).
Access all control sengs.
Once you build a preset, you can save it as one of the 64 preset
slots the oers.
• Click on then choose your preset number:
• Preset can be reset by the user using buon
• You can load your preset at anyme on Program or Preview
using the load buon.
Once your setup is complete, click on the tab to start building
your presets.
• Resize or reposion your layer by clicking and dragging the layer.
• Load and place all your layers with your mouse and use the take
buon to send it to your program
• Drag sources into layers to change the source
Other sengs are available for layers, please refer to the user
manual.
Choose your operaon mode using the setup menu
to drag and drop your unused output to
the selected mode.
Under , click on the selected output on the
le to have access to the setup. Then choose the format and
rate. (Rate choice is only available for preview output, the main
output will use the rate dened under
)
Under this menu you have access to the feature,
Opcal SFP restart and test paern possibilies.
Always try to use nave resoluon of your screens/
projectors to avoid addional scaling.
Click on to have an overview of your
inputs.
Click on to launch the automac detecon of all
inputs once all sources are connected and turned on.
Click on the le on the individual input setup in order to dene
your input
As each input has mulple input plugs, you must choose one
plug to display as this input. The remaining non-displayed plugs
remain acve and can sll be congured.
Click on your in order to choose the displayed
input.
Click on the to start setup of a plug not currently
chosen as the acve plug. (Not necessarily displayed).
#1 = Source is on the Program output
#2 = Freeze enable
#3 = Stand-by buon
#4 = Preset Selecon
#1 = Source is on Preview
#2 = Funcon available for modicaon
Contextual buon
Layer/source selected or is currently acve
on the Program output
Layer/source selected or is not currently
acve on the Program output