User manual
72
If you need to use your own Software Control program from a
PC or automation, the device allows communication through an
ASCII code protocol. All commands can be found on the CD-
Rom shipped with the Eikos in the “Programmer’s Guide” le.
All Analog Way products equipped with an RS232 input are
compatible with Crestron, AMX, Medialon, and most major
control systems. TCP/IP control ports are also available on
most Analog Way products, as standard or as options.
To control an Eikos product with an External Remote Controller
(PC Software Control - Touch Pad Controller…) follow the
indications below :
1. First establish an RS-232 communication between the
Remote Control Software and the Eikos, in order to setup
the LAN parameters of the product.
2. In the “Control” - “Eikos LAN Setup” menu, congure the
connection of the Eikos product in UDP mode and setup
the Local and Remote Addresses as well as the Local and
Remote Ports in concordance with your Network.
3. Congure the TCP/IP address of your External Remote
Controller.
In example: 192.168.000.001
4. Setup the UDP connection of your External Remote
Controller in concordance with your Network.
In example on the Remote Software in the “Control” -
“RS232/LAN Setup” - “LAN/Setup” menu :
5. Setup the LAN parameters in UDP mode in the “Console”
- “LAN Setup” menu.
In example: RK Address: 192.168.000.002
Remote Address: 192.168.000.010
Gateway Address: 192.168.000.001
RK Port: 10500
Remote Port: 10500
Netmask: 255.255.255.000
6. Select the LAN communication port in the remote controller
console - “RS232/LAN port” menu.
7. You can now control your Eikos product with an External
Remote Controller.
7-3. EXTERNAL PROGRAMMING