User manual
59
5-2. WORKING WITH THE RCS
Operating mode
To choose the operating mode you want your Eikos to work
in, simply click the “Mode” tab, then select the desired mode
by clicking on one of the two mode buttons (Mixer or Sync
Matrix).
* NOTE * : for further detail on different modes, restrictions
and settings, please refer to the “Working with the Eikos”
chapter, p.29, and the “Home Menu” chapter p.47.
Source input conguration
Once your Eikos is wired up to your PC, the rst step in
properly conguring your machine is to individually select
and parameter your inputs.
1. Click on the “Inputs” tab of the RCS.
2. In the Plug column of the “Input” page, select the plug
type by clicking the appropriate eld.
3. Activate the input in the Enabled column if it is not.
4. In the scroll-down menu of the Type column, select the signal type connected to that plug.
5. Repeat steps 2 to 4 for all sources connected to the rear panel of your Eikos.
6. Click on the “Inputs” tab to return to the main screen.
Source output conguration
1. Click on the “Outputs” tab of the RCS.
2. Select the type of plug which is connected to outputs
1 & 2 of your Eikos by clicking in the appropriate eld
in Analog Type or DVI Type for both Main and Preview
outputs.
3. Select the appropriate output format and output rate.
4. Click on the “Outputs” tab to return to the main screen.
The Output menu also allows you to generate test patterns. The test patterns available through the
Output menu let you quickly and reliably setup your projectors.
* NOTE * : Be sure to turn the test pattern off to display your sources again.