User manual

44
The Frame/Logo can be memorized from Output 1 or 2. To record a frame/logo please refers to the
chapter “Capturing still Frame/Logo” in the Mixer mode.
To use a Frame/Logo, refer to “Working with frame/logo”.
As a source, each frame/logo can be used by both output, you just have to select the correct matrix#
button rst.
Working with Frame/Logos
OUTPUT #1 OUTPUT #1
OUTPUT #1OUTPUT #1
OUTPUT #2 OUTPUT #2
OUTPUT #2OUTPUT #2
3- Cpy&H.pos Flip mode: the output #2 will be exactly the same as the output #1 except the fact
that the selected layer will have his H position ipped (standard Mirror
mode).
4- Cpy&H.Flip all modes: the output #2 will be exactly the same as the output #1 except the fact
that the selected layer will have the H position and data ipped.
NOTE: Remember that to simplify the use of this feature, you need to manipulate the Output #1.
In mirror mode, the Output #2 will follow the desired steps.
NOTE: Every change on the Output#2 will have an effect only on the Output#2 but remember
that if a change occurs on the Output#1 after that, the Output#2 will change automatically (in
mode 2/3/4).
❸
❹