User manual

Input selection settings

Source Input selection

Source output selection

Output selection settings

Working with Native Matrix Mode

Same as MIXER Mode.

* NOTE *: If you want to use HDCP content from your sources, be sure plugging HDCP compliant

screens or projectors. If it’s not the case, the output image could be disabled.

To activate the native matrix mode:

Mode Menu → Native Matrix mode menu → Standart Mode or Mirror Mode

You’ll nd all menus from the mixer mode in the main menu except some specic matrix function

added.

To work with native matrix mode, you have to use the Matrix # buttons rst.

B- SETTINGS IN NATIVE MATRIX MODE

To set up the outputs, go in the Output 1 or Output 2 menu and choose rst the adapted format/

resolution and then the adapted rate for your screens by using the knob button and the Enter button.

Output# → Output Format → Output rate

You can also in the Output 2 menu, synchronise all the changes from the Output 1 to the Output 2

by checking the case Synch w/Out 1. It allows you to set up just one time your outputs.

Output 2 → Synch w/Out 1

Try to use the native resolution of your screens/projectors in order to obtain the best image quality.

* NOTE *: The output status can provide you all information about the output in real time. This fea-

ture is particularly needed when HDCP is used thanks to the HDCP status.

*All changes have to be validating by pressing the Ok button in order to be saved*

Video Out

In Native Matrix mode, the menu “connection mode” allows you to choose recording Output 1 or

Output 2.