User manual
30
To set up your inputs:
Input menu → Auto settings
You can also do it manually on each input# using the ENTER and the Knob button and set up the
inputs type one by one.
You can check your actual input conguration too using the cong status:
Input menu → Cong Status
You can nd several settings for each input (some settings are specic to some signal type):
- Type: to set up your input type (Computer, video etc..)
- Enabled/disabled: to enable/disable input#
- Audio input: to set up the audio regarding the input
- H synch load: the change the load of the signal (Hi-Z, 75 Ohms)
- EDID: to set up the EDID in terms of resolution and rate
- Status: to summarize the input status
Concerning the DVI inputs, a specic feature allows enable/disable the HDCP receiver for the input
chosen. It can be very useful especially using a Mac:
Input menu → DVI # → HDCP enabled
* NOTE * : The input status is available at any time in status input menu and can give you
information about format rate and HDCP.
Input selection settings
Source Input selection
Plug your sources thanks to the 6 universal inputs, 2 DVI-I Inputs or 4 SDI inputs.
Don’t forget that the 2 DVI-I inputs can be used with DVI-D computer sources (DVI1 & DVI2) but also
with a DVI-A adaptator for analog sources too (source #5 & 6) shipped with your unit.
Be sure to screw all the sources to be sure to not disturb the signal.
Output selection settings
To set up the output, go in the Main Output or Preview Output menu and choose rst the adapted
format/resolution and then the adapted rate for your screens by using the knob button and the Enter
button.
Main Output → Output Format → Output rate
Try to use the native resolution of your screens/projectors in order to obtain the best image quality.
You can also in the Preview Output menu, synchronise all the changes from the Main Output to the
Preview Output by checking the case Synch w/Out 1. It allows you to set up your outputs via the
output 1 menu.
Preview output → Synch w/Out 1
Source output selection
Once your inputs have all been congured, the output settings of the Eikos must be set according to
the machines plugged on your Eikos main and preview outputs (video projector, preview monitor...).
* NOTE * : If you want to use HDCP content from your sources, be sure plugging HDCP
compliant screens or projectors. If it’s not the case, the output image could be disabled.
A- SETTINGS IN MIXER MODE