User guide

ManualsBrandsAnalog Way ManualsAccessories communicationSecure Power Unit

Secure Power Unit - Ref. SPU001

QUICK START GUIDE

Thank you for choosing Analog Way and the Secure Power Unit. By following these simple steps, you will be

able to set up and use your external power supply secure unit. Dedicated to Analog Way’s LiveCore™ series

(SmartMatriX Ultra, Ascender 32 & Ascender 48), the Secure Power Unit allows a redundant supply and a

protecon against power cuts or failures.

• 1 x Secure Power Unit 1 RU Frame (SPU001)

• 1 x LiveCore™ power supply (OPT-SPS)

• 1 x SPU baery (OPT-SPUBATTERY)

• 1 x SPU adaptator block with aached cable

• 1 x IEC power supply cable

• 1 x Grounding cable

• 1 x RS232 cable

• 1 x Rear rack rail kit

• 1 x Quick start guide*

* Quick start guide is also available on www.analogway.com

WHAT’S IN THE BOX

PANELS DESCRIPTION

TEST buon Baery charge

PSU Status

SpeakON™

DC Power 12V

Baery Power Supply Unit 2 Power Supply Unit 1

RS232 port

Ground

Summary of content (4 pages)

PAGE 1
QUICK START GUIDE Secure Power Unit - Ref. SPU001 Thank you for choosing Analog Way and the Secure Power Unit. By following these simple steps, you will be able to set up and use your external power supply secure unit. Dedicated to Analog Way’s LiveCore™ series (SmartMatriX Ultra, Ascender 32 & Ascender 48), the Secure Power Unit allows a redundant supply and a protection against power cuts or failures.
PAGE 2
OPERATION OVERVIEW THE TEST BUTTON Pushing shortly the TEST button performs a test of the Secure Power Unit. It enables a view of the Secure Power Unit supply and of the battery charge without any LiveCore™ device connected (or in standby). A long press will perform a forced charge of the battery if the battery charge is lower than 95% (only when the LiveCore™ device is in standby or without any LiveCore™ connected).
PAGE 3
Web RCS: Setup > Services > SPU INSTALLING THE SECURE POWER UNIT Installation steps are detailed hereafter for a first installation or a hot swap. Please make sure to carefully follow instructions. First installation: Please take the usual safety measures against ESD. All devices must be disconnected from the mains power.
PAGE 4
STEP #3 2 STEP #4 1 1 2 The third step is to connect the Secure Power Unit to the LiveCore™ through an RS232 cable. It will provide information about the Secure Power Unit directly on the Web RCS interface. Connect the ground between the Secure Power Unit and the LiveCore™ device. 1 The last step is to power the Secure Power Unit. The LiveCore™ device is ready to run safely. WARNING: In order to power the Secure Power Unit, plug IEC cables first in the Secure Power Unit then plug into the mains power.