Owner's manual

8.3.1 Source Input selecon

8.3 



Same as Mixer mode



Same as Mixer mode



Same as Mixer mode

 Layer A Layer B

Posion YES YES

Size YES YES

Zoom YES YES

Transparency YES YES

Border YES YES

Opening eects YES YES

Closing eects YES YES

Smooth Move YES YES

The layers are used in the same way as the Mixer mode. A source has to be selected to acvate the PIP set-

ngs. Each layer has its own sengs, Layer A on Output #1 is not linked to Layer A on Output #2 in terms of

sengs.

All layers sengs are available in the Layer menu once the layer is selected.

NOTE: Take a look at the blinking of the Matrix mode buon to always know on which output you are working

on.



Same as Mixer mode.

NOTE: If you want to use HDCP content from your sources, be sure to plug HDCP compliant screens or

projectors. If it’s not the case, the output image could be disabled.



To set up the outputs, go in the Output #1 or Output #2 menu and choose rst the appropriate format/reso-

luon and then the adapted rate for your screens by using the  buon and the ENTER buon.



You can also in the Output #2 menu, synchronise all the changes from the Output #1 to the Output #2 by

checking the case Synch w/Out 1. It allows you to set up both outputs at the same me.

Output #2 > Synch w/Out 1

Try to use the nave resoluon of your screens/projectors in order to obtain the best image quality.

In all condions, the second live layer (layer B) will have the keying funcons enabled. You can

not disable it. Please refer to the keying chapter to know how to adjust the keying sengs.