Owner's manual

59
8.2.19 Layer transions & eects
2. In the Layer Selecon secon, press the Layer A buon. The buon will start blinking. On your Preview
screen, Layer A will appear as a color rectangle. The parameters of the layer will automacally appear on
your Saphyr VFD menu screen.
3. In the Layer Menu, make the posion, size, border and transparency sengs you like, then select Opening
Eect in the layer opons, press the ENTER buon and select Type. Select Slide Le - Right for example,
and press the ENTER buon to conrm. Navigate to Duraon in the Opening Eect sub-menu, and set the
duraon of your eect by rotang the SCROLL knob and pressing ENTER.
Repeat the procedure in the Closing Eect sub-menu to determine the way your layer will close. Try Slide
From Le - Right for the closing type with a duraon of 1.5 seconds for example.

To capture a logo, display the exact content you want to save on the Program or Preview screen, you can use
the freeze buon if you want. Then follow these steps:

To set up your logo you have several features available:
- Posion / Size Adjustment
- Keying type
- Luma / Chroma key
- Cut out color.
Select the logo number you want to save and wait unl the unit nishes saving. Your logo is now saved and
you can use it through the logo buon.
You can save up to 8 logos with the Saphyr.
The capture of logos can be done only with the following condions:
- The capture can be done on the Program output or the Preview output
- The disappearance of logos on the Preview and Program output is normal during saving.
The logos are captured with the same size as is visible on the Program output without any form of adjust-
ments. If zooming is required, resize the layer or use the layer zoom or input zoom.
A logo captures the state of the dened area on the specied output at the Program output resoluon, and
must be recalled using the same output resoluon. Resizing or other image manipulaon of the captured
logo is not possible.
The capture zone is outlined by a white rectangle and includes the pixels beneath the white border. The non-
captured area has a reduced brightness.
Logo capture is limited in the number of pixels being captured. When the logo capture area is resized, exten-
ding the horizontal size may reduce the vercal size to compensate.
Logos can also be captured and displayed with transparent areas. By adjusng the keyer in the logo capture
menu, the porons of the captured area can be keyed away and captured as transparent.
The logo “Cut out color” can help display which porons of the image will be captured as tranparent.