u User Manual

41

The layer layout gives you access to several predened layouts with 2 or 1 layers already sized and placed into
the output.
Once clicking on the layout buon, you have access to the presets with 2, 1 layers or all layouts.
Two other opons are available below:
 layers already displayed and not included into the
chosen layout will be cleared
  layers already displayed and not included into
the chosen layout will be faded out during the transion. They are sll
present on the preset but with a 100% transparency.
7.3.3 Eects

Adjust the size horizontally (X) or vercally (Y), then adjust the width and the height of your layer. You can
use the cursor or directly enter a value. To keep the aspect rao by using the cursor, please enable the KEEP
ASPECT RATIO buon. You will nd it on the right of the width and height cursors.
Transparency
Use the Transparency to give at your layer a transparent eect. Layers behind the transparency layer will
show through more or less based on the transparency value.

The Cropping feature allows you to cut the part of the image you don’t want. Simply adjust the size horizontally
or vercally and then adjust the posion to display only the desired content. This crop is a layer property, all
inputs displayed in this layer will be cropped. Do not confuse this seng with the input crop which is specic
to an input.

On the Transions secon, you can lter which transions you want to see. For Example, you can show just
the Slide, Wipe transions.
Each layer has an opening and a closing transion. The opening eect will be applied when the layer switch
from a source to another source or when the layer is switching from empty and appears with a source.
To set up the duraon of the transion, please see below the ming and duraon sengs. If you want to
force the layer to perform a closing and opening transion, see FORCE TRANSITION.


The Force Transion buon disables the cross-transion between two sources into the same layers. Enabling
the Force Transion, it forces the layer to go out and then go in with the desired eect instead of mixing
directly the two sources.

Enable the Smooth Move to perform a smooth transion on the layer. Disable the smooth
move if you require a constant speed move.