u User Manual

29
7.2.3 Screens
In the screen conguraon, you will nd the state of your screen. It indicates the screen resoluon, the
maximum number of layers you can use.
You will nd conguraon for the Quick Frame and the background color too.
The Quick Frame will be your emergency frame that can be displayed in front of
every layer. Here, select the frame slot number to be displayed as the Quick Frame.
Into the PREVIEW secon, you have the possibility to enable or not the PREVIEW aspect.
PRESET ASPECT: disabling this opon disable the Preview indicaons on your Preview
monitor, such as the blinking layer wireframe, and source number.
7.2.3 Screens
7.2.4 Preview
7.2.5 Misc
PRESET TOGGLE: by default, the device will not swap the Program and
Preview busses during each TAKE. Disabling this opon will leave the
Preview bus unchanged during each TAKE, and only the Program will be
updated. When this opon is enabled, the Preview and Program busses will
be swapped during each TAKE.
AUTOTAKE: enable the automac TAKE. Each me a source is changed on
preview, it triggers a TAKE to be launched.
DYNAMIC FIT: enable or disable the automac recognion of black band for
digital content. The size and the aspect rao of the layer are automacally
adapted.
FREEZE MODE: choose to freeze all inputs or only one input when you use the freeze funcon.
PIP BACKGROUND COLOR: here you chose the automac color of PIP background, black is the default color.