X Instruction Manual

Ref. QMX150

Thank you for choosing  and the . By following these simple steps, you will be able to
set up and use your powerful 8x2 Seamless Matrix Scaler based on ’s new Midra™ plaorm within
minutes. Discover the  capabilies and intuive interface while conguring your rst show and
unleash your creavity for a new experience in show and event management.
• 1 x 
• 1 x Power supply cord
• 1 x Ethernet cross cable (for device update)
• 1 x Remote Control Soware (RCS²)*
• 1 x Set of 6 audio 5-pin screw terminals
• 1 x Front Rack Ears (the parts are stowed in the packaging foam)
• 1 x User Manual (PDF)*
• 1 x Quick Start guide*
* User manual, quick start guide and the RCS² are available on www.analogway.com



You may wish to reset the unit to factory sengs to get
started. Go to:       

 Select the Output resoluon that matches the nave
resoluon of your display. You will next be prompted to
choose enable follow mode if desired and output rate.


Do the same for Output #2.
 Inputs can be congured automacally using the Auto-
Set All funcon. 
It will scan each input and detect the sync type that is
plugged in. You can sll do an Autoset or manual setup per
input.
The  has 3 layers available called:  
  and    available with
controllers.
To display a source, select the output, select a source
(it will blink). Press  to transion your source from
Preview to Program output.
There will always be an output selected and a source
selected (blinking).
To display a keyed Titling layer, you will need the RK-350
or ORC50, select a layer, select a source
into it, apply a keying eect on the the source to be able to
see it on your Program output.
 To clear the keyed layer or any other layer, select 
and select the output. Press .
 If you would like the Program and Preview to toggle/
ipop during each TAKE, enable this feature by going to

Once enabled, everything on the old Program output will
become the new Preview aer each TAKE. See the next
page which describes the buon lighng color code and
other front panel features.

- Sources seamlessly switched in the   of each
outputs. (Only 1 layer)
-  over the . (No more seamless
eects)

   


If required, front handles of the
device can be dismantled, but
with cauon. The original screws
removed must not be reintro-
duced to their locaon without
handles in place. Substanal da-
mages can occur, including risk of
electric shock from the mains vol-
tage. Only M4x12mm screws can
be used. (They are supplied with
the unit.)