Owner's manual

USING FRAME & LOGO INSERTION

4-1. LOGO INSERTION

This function allows storing up to 8 static logos & 1 animated logo in order to key them into the displayed image (up to

2 logos simultaneously).

IMPORTANT : The output format used when displaying logos should be the same as the one used during the

logo storing.

• HOW TO STORE A LOGO :

1) Selectthesourceofthelogotobestored(withtheINPUTSELECTIONbuttons).

2) Select the record logo mode (LOGOS/FRAME > record logo or record anim) : the device displays a

white rectangle corresponding to the logo selection area. Then adjust the position and size of the logo

selection area with the LCD record logo/anim menu functions.

NOTE : The logo area is limited to one eighth (1/8) of the displayed area.

3) If necessary, adjust the luma key level (LOGOS/FRAME > record logo or record anim > luma key

level).Thisfunctionallows“erasing”thedarkestportionofthelogoselectionareainordertomake

special logo contour. Otherwise set the luma key level to zero.

NOTE : You can change the color of the “erased portion” of the logo (LOGOS/FRAME > record logo > back. Color).

4) Store the logo into a memory (LOGOS/FRAME > record logo > store > empty or logo x). The memo-

rization of the logo starts and will take few seconds.

NOTE : Follow steps (1) to (4) to store another logo (up to 8).

• HOW TO ASSIGN A LOGO :

NOTE : You can assign the stored logos to one or more of the 8 inputs (up to 2 logos per inputs).

5) In the assignment menu (LOGOS/FRAME > use logo/frame > assignment), select the input that you

want to assign a logo to, then select an index (1 or 2)andnallyselecttherequiredlogo.

NOTE : To remove a logo from an input, select the corresponding input & index and select none.

6) WiththeINPUTSELECTIONbuttons,displaysuccessivelyallyourinputstoverifyyourlogoassign-

ment. If no logo appears on an input: verify that the LCD display function of the corresponding input is

not set to the OFF position. In this case press ENTER to set it ON(seehowtodisplayOFForONa

logo).

• HOW TO DISPLAY A LOGO OFF or ON :

7) ToturntheassignedlogoOFForONofaninput,selectthecorrespondinginputinthedisplay menu

(LOGOS/FRAME > use logo/frame > display) and press ENTERtochangethestatus(ONorOFF).

NOTE : When turning a logo ON or OFF, this one appears/disappears with a fade effect. You can adjust

the duration of this fade effect (LOGOS/FRAME > use logo/frame > fade duration).

IMPORTANT : You can also use the front panel LOGO button (Fn then LOGO) to turn the logo ON or OFF of the

selected input.

• HOW TO ADJUST THE LOGO POSITION :

8) Selecttheinputwiththelogotobeadjusted(withtheINPUTSELECTIONbuttons).

9) Intheassignmentmenu(LOGOS/FRAME > use logo/frame > assignment), select the input and the

logo to adjust. Then adjust the logo position with the H &V position functions.

• EXAMPLE OF LOGO INSERTION :

Logo source

(white border = logo area)

Video source Video source with inserted logo

(logo recorded with luma key)

PAGE 21