User manual

35
7.2.7 Input management
 format and size of the input,
 Black: select Black to transform your input in a uniform color (black),
 use this buon to freeze the specic input,
 choose the EDID for the selected plug.
Under the HDCP secon, you can:
- Enable/disable the HDCP communicaon feature
- Read the HDCP status, If the HDCP status says Acve, this output connecon is currently ulizing HDCP to
protect the signal. if the HDCP status indicates Idle, this output connecon is currrently not ulizing HDCP.
Next is the IMAGE tab, where you can nd all sengs about the display of your input:
Under the COLORIMETRY secon, you have:
 dene the selected input luminosity level,
 dene the selected input contrast level,
dene the selected input color level (0:black and white, full: full color),
 set up the hue phase of your NTSC signal.
Under the USER GAIN secon, you nd:
 increase/decrease the Red/Green/Blue level of your input.
Next you have the ASPECT tab. All sengs about the blanking and aspect rao are available there:
Under the BLANKING ADJUSTEMENTS:
- you can manually adjust the input blanking with the V&H size or posion.