Owner manual
If you need to use your own Software Control program from a PC
or automation, the device allows communication through an ASCII
code protocol. All commands can be found on www.analogway.com,
in the [Technical Support] menu, [User’s Manuals] menu.
All Analog Way products equipped with an RS232 input are
compatible with Crestron, AMX, Medialon, and most major control
systems. TCP/IP control ports are also available on most Analog
Way products, as standard or as options.
To control an PLS200 product with an External Remote Controller
(PC Software Control - Touch Pad Controller…) follow the indications
below:
1/ First establish an RS232 communication between the Remote
Control Software and the PLS200, in order to setup the LAN
parameters of the product.
2/ In the “Control” - “Pulse LE LAN Setup” menu, congure the
connection of the PLS-200 product in UDP mode and setup the
Local and Remote Addresses as well as the Local and Remote
Ports in concordance with your Network.
3/ Congure the TCP/IP address of your External Remote Controller.
In example: 192.168.000.001
4/ Setup the UDP connection of your External Remote Controller in
concordance with your Network.
In example on the Remote Software in the “Control” - “RS232/LAN
Setup” - “LAN/Setup” menu :
5/ Setup the LAN parameters in UDP mode in the “Console” - “LAN
Setup” menu.
In example: RK Address: 192.168.000.002
Remote Address: 192.168.000.010
Gateway Address: 192.168.000.001
RK Port: 10500
Remote Port: 10500
Netmask: 255.255.255.000
6/ Select the LAN communication port in the remote controller
console - “RS232/LAN port” menu.
7/ You can now control your PLS200 product with an External
Remote Controller.
7-3. EXTERNAL PROGRAMMING
48