User Manual


On startup, the Orchestra² tacle screen will display the
User page. The rst me you use the Orchestra², you will
have to create a new user.
1. Press the New User buon on the tacle screen
2. Name the new user as required and press the OK
buon to validate your choice. Press OK to skip
password creaon.
3. On the User page, choose the user you just created,
and press the OK buon. The Orchestra² will display its
default menu screen.

The Orchestra² System Conguraon page lets you
adjust properes like the IP address of the Orchestra².
1. Press System on the tacle screen. The Network
Conguraon tab will be displayed.
2. Select the Lan Sengs opon, rotate the
corresponding knobs to change the IP address of
the Orchestra² (IP1,2,3,4) or press the <Default>
buon to restore the address to 192.168.0.9.
Press the OK buon to validate
3. Press OK again to Exit the system page.

When starng with the Orchestra², you will need
to create a new show.
1. Press the Shows buon on the tacle screen
then “Create a New Show” buon.
2. The Orchestra² will display the Show Edit Name
screen, you can now enter a new name. Choose
a name for your show, then press the OK buon
to validate your choice.
3. The Orchestra² will display a blank show page.

1. Select a Screen in the Screen secon of the Orchestra²
by pressing one of the six available buons. The Screen
page will appear on the Orchestra² tacle screen.
2. Press Screen Setup on the tacle screen.
3. On the <Screen Setup>, select the slave device type
and mode. Press Edit to rename your screen.
4. Press Edit Devices. Add Device. Using the tacle
screen, Congure the communicaon sengs of the
device that the ORC50 will control.
5. Press the OK buon to validate your changes. The
Orchestra² will begin connecng to the congured
device.
6. Press the OK buon to return to the Screen Setup
page.

1. In the Screen Setup page, press Edit Outputs and
select the output, Main or Preview, you wish
to adjust, then congure the output format
(resoluon), output rate, output type required.
2. Press Paern, and select an available paern
to check your output sengs on screen. Press
Paern again, and select None to revert to your
image on screen.
3. Press the OK buon to return to the screen
setup page.

1. In the Screen Setup page, press Edit Input, you can
manually congure the type of plug, the signal type or
press the AUTO SETTING ALL buon, for an automac
setup of your inputs.
2. Press OK buon.

Please refer to the So Edge Setup Chapter of the
User manual.

In the screen setup page, to access source image
sengs, press the IMAGE SETTINGS buon.

1. In the screen setup page, press the LOGOS/FRAMES
buon.
2. Select a source you wish to use as a logo or frame.
3. Choose the memory slot to save the Logo/Frame into,
edit size, posion with the joysck, and the keying
sengs by rotang the approriate knobs.
4. Press STORE to store your logo or frame.
DC 100-250 VAC
2A 50-60Hz
  Connect
the Orchestra² to 10/100
Ethernet LAN using this fe-
male RJ-45 connector: used
to control switcher

Not in use

Clone of the tacle screen

For installaon
 Serial port
(not in use)
SETTING UP THE ORCHESTRA²
CONFIGURING THE SHOW
REAR PANEL DESCRIPTION