Owner's manual

42
8.1 So Edge blending
8. SOFT EDGE BLENDING
8.1 So Edge blending
8.2 So Edge setup
If you want to create a So Edge setup using only one unit, you need to set the unit in «Embedded SEB» mode
and connect your Le projector to «Output 1» (Main) and your Right Projector to «Output 2» (Preview).
In this «Embedded SEB» mode type of setup, your unit does not have a Preview anymore, unless the unit is
equipped with an Oponal Video Output Board. In this case, you can use the Oponal Video Outputs for your
Preview purposes. (Adjust the «Video Out» to the format of the monitor connected to it).
If you want to do a So Edge setup using mulple units, you need to set all of the units in «Mixer» mode and
connect the projectors to the «Output 1» (Main) of each unit.
To correctly clean setup your So Edge, follow these simple steps.
It is important to do the setup in the right order as follows:
1. Switch ON your Unit(s).
2. In the «Control» menu, run an «Erase Memories» (on all units).
3. In the «Control» menu, run a «Default Values» (on all units).
4. If you wish to setup a Soegde with only one unit, in the «Mode» menu select the «Embedded SEB» mode.
If you wish to use mulple units, in the «Mode» menu select the «Mixer» mode.
5. In the «Output» menu, set the «Output Format» at the same resoluon (nave resoluon) as the projec-
tors that you use.
6. Physically align the projectors so that their internal test paerns are correctly displayed on the screen. To
do a correct projecon, the projectors must be posioned at 90° to the screen in the X and Y axes.
NOTE:
• If you must move image, laeraly, always move VP.
• When moving image vercaly, use the lens shi on your VP.
NEVER USE KEYSTONE
Right
angle
Screen
Screen
VP
VP
Screen
Screen
Right
angle
VP
VP