Owner's manual

26
4.2 Show sengs
The Controls page allows you to select the Tally trigger on the slave device. The Controls page also allows you
to reset a device to its default values, or erase all image sengs present on the device.
To setup a tally signal with the Orchestra²:
1. On the Screen Setup page of the Orchestr, press Controls.
2. Press one of the four available Tally dropdown menu to select
the source you want to use as a trigger.
3. Press the OK buon to return to the Screen Setup page.
To erase all image sengs on the slave device:
1. In the Screen Setup page of the Orchestr, press Controls.
2. Press Erase Memories.
3. Conrm by pressing Yes on the conrmaon popup.
4. Press the OK buon to return to the Screen Setup page.
To reset all sengs on the slave device:
1. In the Screen Setup page of the Orchestr, press Controls.
2. Press Default Values.
3. Conrm by pressing Yes on the conrmaon popup.
4. Press the OK buon to return to the Screen Setup page.
4.2.11 Controls Menu