Owner's manual

25
The Image Sengs page allows you to ne tune the source image of any input you have previously entered
into your Screen.
NOTE: This menu is accessible when working directly with live sources on the Orchestra² front panel (for
more detail on Image Sengs, please refer to the Layer Sengs chapter).
1. In the Screen Setup page of the Orchestr, press Image
Sengs. The Image Sengs page will give access to dierent
sengs depending on whether the selected source is a digital
or an analog source.
2. Select the source you wish to work on. Buons in the Source
Preview secon will light up, indicang the sources are
available.
3. Select the Adjust, Advanced, Posion/Size, Opmize, Aspect
Rao, Zoom or Keying tabs to adjust those sengs of your
source image by rotang the corresponding knobs, or selecng the opons required.
4. When you are sased with your image sengs, press the OK buon to return to the Screen Setup page.
4.2 Show sengs
The Logos/Frames page allows you to capture and store logos and frames (see also Frame Background).
1. In the Screen Setup page of the Orchestra², press Logos/
Frames. The buons in the Source Preview secon of the
Orchestra² will light up, allowing you to display the source you
wish to capture. The buons in the Layout secon will also
light up, and give you access to your logo or frame parameters.
2. Select the source you wish to capture by pressing a SOURCE
PREVIEW buon (#1 to #8), then select the type of capture
you wish in the dropdown list. In this case, we will see how
to record a logo. A white rectangle will appear on screen to
indicate the area to capture as a logo.
3. Select the memory you wish to store the logo/frame into (#1 to #8) in the Memory Slot dropdown list.
4. In the Layout secon, press the POS buon, and with the help of the joysck, move the rectangle on screen
to the area where your logo is. Resize the outline to t the logo if need be, by pressing the SIZE buon then
adjusng with the joysck.
NOTE: To move the source, rather than the container rectangle itself, press the source tab and adjust size and
posion with the help of the joysck as described in step #4.
5. Press the keying tab to adjust the keying sengs for your logo.
6. Once all your logo parameters are set, press Store in the
Capture Tab. The Orchestra² will display a progress status bar
while the device memorizes the logo.
7. Press the OK buon to return to the Screen Setup page.
NOTE: To record a logo in So Edge Blending Mode, you need to
press Source, then press Switch Extended.
4.2.9 Image Sengs
4.2.10 Logos & Frames