Owner's manual

23
To properly synchronize the slave device with your Orchestra², you must setup the inputs of the device into
the Orchestra².
1. In the Screen Setup page of the Orchestra², press Edit Inputs.
2. Select the input you wish to parameter, then select the plug type, and the type of signal. The status box (by
the Select Input dropdown menu) should display image resoluon and rate.
NOTE: If you are working with a matrix, you can route your image through the matrix via the Matrix Mapping
tab (see also Working With a Matrix).
3. Press the OK buon to conrm input sengs and return to the Screen Setup page.
The Audio Edit tab will give access to audio in/out parameters
such as levels, balance or volume.
The Edit Sources tab allows to map device inputs, logos or frames to source buons on the Orchestr front
panel.
1. In the Screen Setup page of the Orchestr, press Edit Sources.
The buons in the Source Preview secon of the Orchestr
will light up, allowing you to select the source you wish to
work with.
2. Select the source you wish to parameter, then press Edit to
give the source a new name if required.
NOTE: If you are working with a matrix, you can map matrix inputs to sources, assuming you have dened
links between the matrix and your device in the Edit Inputs page (see the Input Conguraon chapter
and the Working With A Matrix chapter).
4.2 Show sengs
4.2.5 Input conguraon
4.2.6 Audio conguraon
4.2.7 Source conguraon
3. Press Paern to generate a paern on the screen/device plugged to the slave device video out card if you
wish to check the video Out setup.
4. Press TYPE to select the type of signal
5. Press ADJUST to tweak the Gamma value of the output selected.
6. Press the OK buon to conrm and return to the Screen Setup page.