Owner's manual

22
Once your device has been added into a Screen, you can congure its outputs.
1. On the Screen Setup page of the Orchestra², press Edit Outputs. The format screen is displayed by default.
2. Select the output, Main or Preview you wish to congure, then select the output format (resoluon),
output rate, needed. On certain devices, you can also disable/enable the HDCP detecon on the outputs.
3. Press Paern, and select a paern from the dropdown menu to check your output sengs are properly
congured. When you are sased, press Paern again, and choose none to revert to your image on
screen.
4. Press TYPE to select the type of signal
5. Press ADJUST to tweak the Gamma value of the output selected.
The Video Out tab will be available only if the slave device has an oponal video card installed (for example a
Di-VenX II with opon VO-8044).
1. In the Screen Setup page of the Orchestr, press Edit Video Out.
2. Select the display mode for the slave device video out card, then select the output format (resoluon),
output rate, and signal type. On certain devices, you can also disable/enable the HDCP detecon on the
outputs.
4.2 Show sengs
NOTE:
• Make sure LAN sengs match those of your device.
• Only TCP and UDP protocols are supported on the Orchestra². We recommend using the TCP protocol.
4. Press the OK buon to conrm and return to the Devices page. The Orchestra² will connect to the device.
Press the OK buon to return to the Screen Setup page.
NOTE:
• Screen parameters should all be available now that a device has been added into the current Screen.
To control several Di-VenX II in so edge, add the Di-VenX II devices in Mixer Mode in only one screen.
You should have several Di-VenX II into the Edit Devices menu.
4.2.3 Output conguraon
4.2.4 Video Out conguraon