Owner's manual

21
For the Orchestr to start pilong your external device(s), you must create a show to work in. The show
will hold parameters for any connected device (as well as all other show parameters such as inputs, outputs,
screens, presets...).
1. Press the Shows buon on the touch screen, then press Create a New Show.
2. The Orchestr will display the Show Edit screen, which allows you to name the new show as required.
When you have chosen a show name, press the OK buon to validate your choice. The Orchestr will
display a blank show page.
For the Orchestr to pilote external devices, they must be set up as Screens. To setup a Screen, do the
following:
1. Select the next available screen (#1 to #6) in the Screen secon
of the Orchestra². The Screen buon will blink, and a display
of your empty screen will appear on the Orchestr touch
screen.
2. On the Orchestr touch screen, press Screen Setup to enter
the Screen conguraon page, then press Edit if you wish
to give your Screen a dierent name than the default name
(Screen #1 to #6). Change the name of your Screen accordingly,
and press the OK buon to validate and return to the Screen
Setup page.
To add a device to a Screen, acvate it, and start pilong it, do the following:
1. In the Type dropdown menu on the touch screen, select the
kind of device you want to use in your Screen (in this case a
Di-VenX II).
2. In the Mode dropdown menu on the touch screen, select the
mode you want to use the device in (in this case Mixer Mode).
NOTE: Screen parameters other than Edit Devices will not be
available unl a device is stored into a Screen.
3. Press Edit Devices, and press Add, the touch screen will display a page which will let you select the device
you want the Orchestr to pilote. Press Edit to give the device a dierent name than the default name,
select the communicaon protocol the device is congured in, and change LAN sengs if required.
4.2 Show sengs
4.1.3 Show conguraon
4.2 Show sengs
4.2.1 Screen setup
4.2.2 Edit devices