Owner's manual

19
4.1 Operaonal conguraon
4. STARTING WITH THE ORCHESTRA²
4.1 Operaonal conguraon
When the Orchestra² starts up, the User page will be displayed over the Home page. Here, you can create a
new user, or use an exisng one. The rst me you use the Orchestr, you will have to create a new user.
1. Press the NEW USER buon on the touch screen.
2. The Orchestr will display the User Edit screen, which allows
you to name the new user as required. When you have
entered a user name, press the OK buon to validate your
choice. Press OK again if you do not wish to create a password
for the new user. Otherwise, enter a user password which will
be asked every me you wish to log in as that user.
3. On the User page, choose the user you have just created, and
press the OK buon again. The Orchestr will now display its
home page.
The Orchestr System Conguraon page allows you to parameter the IP address of the Orchestra², caliber
the joysck, the keyboard brightness, set the me, or check the soware version and update it via the USB
port if required.
1. Press the SYSTEM buon on the touch screen. The Orchestr
will display the network conguraon page of the System
menu.
2. Press the LAN SETTINGS buon to enter the IP adress.
3. Rotate the corresponding knobs to change the IP address of
the Orchestra² (IP1, IP2, IP3, IP4) then press the OK buon to
validate.
NOTE: The Orchestr must be on the same network as the devices it is going to control.
4.1.1 User conguraon
4.1.2 System conguraon