User Manual
10. Assembling and devices coupling
The can be used in mulple device conguraon such as a large mul-device screen blend
(hard edge and so edge). In cases where the blended screen involves more than one device, it
becomes desirable to improve the syncronizaon or eects and transions between the mulple units, to
ensure the consistency of any moving images which cross the boundary between devices. The
oers a pair of Device Link ports for this purpose.
To use the Device Link feature in a mul-device setup, you will need one standard straight CAT5 ethernet
cable for each device in the setup, less one. Start by connecng the Cat5 cable from the Device Link output
RJ-45 jack of device 1 to the Device link input RJ-45 jack of device 2. Connue to chain output to inputs unl
you reach the last device. Do not connnect a cable from the output of the last device to the input of the rst
device; these jacks should remain empty.
Straight RJ45 cable Straight RJ45 cable
Up to 8 devices can be connected using Device Link.
The Cat5 based Device Link does not pass any video picture informaon. This link can only be used to
synchronize the ming of eects and processing on devices used as part of the same mul-
device screen blend (Hard Edge and So Edge). Video informaon should be shared among devices using
distribuon ampliers to split the sources to each .
The console is required for mul-device conguraon.