User manual
7. If you are using a multiple units Softedge, split all of your
sources to input each one in the same input # on each unit
(eg.: split your DVD player to input it on input #5 on each unit).
8. In the “Input” menu, set the corresponding “Input Type” for
each input.
9. In the “Softedge” menu, select the appropriate Softegde
“Type”: Horizontal or Vertical.
10. In the “Softedge” – “Test Pattern” menu, select the “SE
Centering” pattern.
☺ Projectors well aligned.
Top and bottom not aligned.
Too small covering area.
Edges not paralleled
• Example: Test pattern in horizontal SE conguration.
11. In the “Softedge – “Covering” menu, adjust the covering so
that the 2 dashed lines of the test pattern line up to make one
straight line in the middle of the Softedge.
If you can not get a perfectly straight line, set the
covering to the best possible and then adjust the
projectors with their Lens Shift to get a perfectly
straight line.
12. In the “Softedge” – “Test Pattern” menu, select
“OFF” to remove the test pattern.
Covering
Area
Light GrayDark Gray Dark Gray
Luma level
Screen
Black
Light Gray
Dark Gray
45