User manual
If you are working with a matrix in your setup, you must add it to your
show. To do so, follow these few steps:
1/ On the Axion2 touch screen, press Matrix Setup to enter the
Matrices page.
2/ Press Add, then press Edit if you wish to rename your matrix.
3/ From the Type dropdown menu, select the type of matrix you
are using.
4/ Select the connection protocol in the Connection panel (we
recommend using TCP).
5/ Press LAN settings to enter the LAN settings page, and
congure the LAN settings accordingly.
* TIP * : please be sure your LAN settings correspond to those of
your matrix device. Many matrices do not support LAN. You will need
an adapter.
6/ Press the [OK] button to return to the Matrices page, which
should now display the matrix you just congured.
7/ Press the [OK] button again to return to the Axion2 show page.
Once the matrix has been added, you must add the slave device to
a Screen.
1/ Select the Screen you wish to work in, and press Screen Setup
on the touch screen.
2/ Press Edit if you wish to rename the Screen, and choose the
slave device type from the Type dropdown menu.
3/ Press Edit Devices, then press Add on the Device Setup page.
4/ Press Edit if you wish to rename your device, then select the
connection protocol for the device.
5/ Press LAN Settings to congure the IP address and port of the
device.
6/ Press the [OK] button twice to return to the Devices page,
which should now display the device you have congured.
7/ Press the [OK] button to return to the Screen Setup page.
WORKING WITH A MATRIX
6-1. MATRIX SETUP
6-2. MATRIX CONFIGURATION
38