User manual

20
The Edit Audio tab will give access to audio in/out parameters such
as levels, balance or volume.
The Edit Sources tab allows to map device inputs, logos or frames to
[SOURCE] buttons on the Axion2 front panel.
1/ On the Screen Setup page of the Axion2, press Edit Sources.
The buttons in the Source Preview section of the Axion2 will
light up, allowing you to select the source you wish to work on.
2/ Select the source you wish to parameter, then press Edit to
give the source a new name if you wish.
* TIP * : If you are working with a matrix, you can map matrix
inputs to sources, assuming you have dened links between
the matrix and your device in the Edit Inputs page (see the
Input Conguration chapter and the Working With A Matrix
chapter).
3/ The Enable checkbox allows you to activate (default) or de-
activate sources. De-activating a source will result in a greyed
button on the Axion2 front panel.
Audio conguration
Source conguration
1/ On the Screen Setup page of the Axion2, press Edit Inputs.
2/ Select the input you wish to parameter, then select the plug
type, and the type of signal. The status box (by the Select Input
dropdown menu) will display the image resolution and rate.
3/ Press the [EDID] button to select the EDID format required.
4/ Press the [AUDIO MAPPING] button to map an audio input to
a video input.
5/ Press the [MATRIX MAPPING] button to map your matrix outputs
* TIP * : If you are working with a matrix, you can route your image
through the matrix via the dropdown Linked To Matrix and Matrix
Output (see also Working With a Matrix) in the Matrix Mapping Tab.
6/ Press the [OK] button to conrm input settings and return to
the Screen Setup page.
Input conguration
The Video Out tab will be available only if the slave device has an optional
video card installed (for example a Di-VentiX II with option VO-8044).
1/ In the Screen Setup page of the Axion2, press Edit Video Out.
2/ Select the display mode for the slave device video out card,
then select the output format (resolution), output rate, enable/
disable HDCP.
3/ Press Pattern to generate a pattern on the screen/device
plugged to the slave device video out card if you wish to check
the video Out setup.
4/ Press the [TYPE] button to select the type of signal required.
5/ Press the [ADJUST] button to adjust the gamma setting via the
corresponding knob.
6/ Press the [OK] button to conrm and return to the Screen
Setup page.
Video Out conguration