User manual

19
Once your device has been added into a Screen, you can congure
its outputs.
1/ On the Screen Setup page of the Axion2, press Edit Outputs.
2/ Select the output, Main or Preview you wish to congure, then
select the output format (resolution), output rate as required.
3/ Press Pattern, and select a pattern from the dropdown menu to
check your output settings are properly congured. When you
are satised, press Pattern again, and choose None to revert
to your image on screen. If it is available, you can enable/
disable the HDCP Detection on your output. This function will
enable/disable the HDCP protocol encryption on your output.
4/ Press the [TYPE] button to select the type of signal required.
5/ Press the [ADJUST] button to adjust the gamma setting via the
corresponding knob.
6/ Press the [OK] button to conrm and return to the Screen
Setup page.
Output conguration
To add a device to your Screen, proceed as follows:
1/ In the Type dropdown menu on the touch screen, select the
kind of device you want to use in your Screen (in this case a
Di-VentiX II).
2/ In the Mode dropdown menu on the touch screen, select the
mode you want to use the device in (in this case Mixer Mode).
* TIP * : Screen parameters other than Edit Devices will not be
available until a device is added into the Screen.
3/ Press Edit Devices, and press Add, the touch screen will
display a page which will let you choose the device you want
the Axion2 to control. Press Edit to give the device a different
name than the default name, select the communication
protocol the device is congured in, and change LAN settings
if required.
* TIP * : Make sure LAN settings match those of your device.
* TIP * : Only TCP and UDP protocols are supported on the
Axion2. We recommend using the TCP protocol.
4/ Press the [OK] button to conrm and return to the Devices
page. The Axion2 will connect to the device. Press the [OK]
button to return to the Screen Setup page.
* TIP * : All screen parameters should now be available as a
device has been added into the current Screen.
Edit devices
Managing with the Axion2
The Axion2 can control the following Seamless Switchers:
Control Mode
DVX8044
EKS500 EKS400
OPS300 OPS200
SMX200 SMX100
PLS300 PLS200
SVU300 SVU200
STE200
STE100
SQD200
EKS550
SPX450
SMX250
PLS350
QMX150
QVU150
Seamless Mixer
x x x x x x x x x x x x x
Seamless Matrix
x x x x x x x x x x x
Quadravision
x x x
So Edge Blending
x x x