User manual
17
To congure an auto launch:
1/ Press the Autolaunch tab.
2/ You can Autologin a selected user and Auto Load a selected show.
To congure the keyboard brightness and parameter the joystick:
1/ Press the Keyboard tab.
2/ Rotate the corresponding knob to increase/decrease keyboard
brightness.
3/ Wriggle and turn the joystick, then let it return to its initial
position. If need be, press the [CALIBRATE] button which will
adjust the neutral position of the joystick precisely.
4/ Rotate the corresponding knob to alter the screen saver time
between 5 min and 8 hours.
On the Axion2 System Conguration page you can parameter the IP
address automatically, calibrate the joystick, the keyboard brightness
of the machine, set the time, check the software version and update
it via the USB port if required.
Press the [SYSTEM] button on the main page. The Axion2 will display
the network conguration page of the System menu by default.
To congure your LAN settings:
1/ Press the [LAN SETTINGS] button you can congure your IP
address, Subnet Mask & Gateway.
2/ Rotate the corresponding knobs to change the IP address of
the Axion2 (IP1, IP2, IP3, IP4) then press the [OK] button to
validate. A message will appear asking you to wait while the
Axion2 registers the new address.
* TIP * : The Axion2 must be part of the same network as the devices
it is going to control.
System conguration
When the Axion2 starts up, the Home page is displayed. Here you
can create new users, shows and congure your console. The rst
time you use the Axion2, you will have to create a new user.
1/ Press the [USER] button on the main page.
2/ Press the [NEW USER] button on the Screen displayed.
3/ The Axion2 will display the User Edit screen, which allows you
to name the new user as required. When you have entered a
user name, press the [OK] button to validate your choice. Press
[OK] button again if you do not wish to create a password for
the new user. Otherwise, enter a user password which will be
asked every time you wish to log in as that user.
4/ On the User page, choose the user you have just created, and
press the [OK] button again. The Axion2 will display the user
Home page.
* NOTE* : The password for the Administrator user is: Password.
STARTING WITH THE AXION2
4-1. OPERATIONAL CONFIGURATION
User conguration