Instruction Manual
PRELIMINARY
56
Save a preset
Once your preset is set up, you can store it into one of the 144 preset slots.
To do that, click on SAVE and choose the number corresponding to the slot
number.
Once saved, you can have access to memory detail, sim-
ply click on it holding the shi buon. You can view your
preset and change the name.
When you aempt to save a preset on an already saved
slot, this message will appear:
7.4.5 Preset load and save management
Add some transparency to a layer. Simply move the cursor
corresponding to the wanted layer.
Under each layer transparency cursor you have an automac
increase/decrease transparency buon which fades in or out
your layer to the selected transparency.
In the same idea, if you want to recall an already saved preset, simply load
it using the LOAD buon on the right side of the Edit mode and select the
slot to load.
You can reset a preset using the reset buon. Using that, all sizes
and posions will be deleted. Your layers will be A0, B0, C0, D0,
E0 and F0. If the “Hide unused layers” buon is enabled and no
more layers are available, you sll have access to the layer selecon on the
right, thanks to the A, B, C, D, E and F buons.
Using the strobe sengs, will allow you to play with the refresh rate
of an input. You will have access to 4 cursors.
Each cursor represents one layer. Increasing the cursor level, you will
perform a strobbing eect on the specied layer. At the boom of
each cursor, a stop buon allows you to stop immediately the eect.
The mirror buon allows you to dene for each layer the way it will
be copied in the preset. You can choose to mirror the layer, ip the
posion, or ip the posion and the data from another screen. To
access this feature, you rst need to be in a hybrid conguraon with
2, 3 or 4 Programs (see chapter: 7.3.4 Screens), then into the Setup
assistant, you need to acvate the “screen mirroring”.