Manual
PRELIMINARY
30
7.3.2 Outputs secon
Once the source is dened, a resume of your outputs sengs will be displayed under the tab STATUS.
WARNING: Conguring the rate to follow a framelock input will lock the output frame rate to match the
selected source. This is useful to eliminate the “strobing eect” which may be visible as an arfact of the
framelocking process. However, be sure that your framelock reference input is a reliable source, as any
disrupons in the reference signal may cause visible glitches on your output, even if the selected framelock
reference input is not currently being displayed.
7.3.3 Screens
In this secon, you can congure the outputs to operate as a Dual-Link output. Simply click on enable if you
want to acvate the output #1 or #3 as Dual-Link.
Dual-Link resoluons (ie: 2560x1600) are only available on the DVI plug on outputs #1 & #3 as they use
resources from both outputs. You will lose the outputs #2 & #4 by acvang the output #1 or #3 as a Dual-
Link output.
The screens page allows you to map a parcular output to a parcular screen or part of a screen.
On the le, you have the available outputs; on the right you have the available screens.
Drag and drop the available outputs into the desired screen. By default, your screens will mapped Output #1
= Screen #1, Output #2 = Screen #2 etc. You can change this order and put for example the Output #3 into
the Screen #1
About the 4 screens, you can change this conguraon using for example a Dual output screen. To do that,
simply increase the size of Screen #1, make it 2x1. And nally drag and drop another output to the second
part of the screen. Having 4 outputs, you can built up to 2 Hard Edge screens of each 2 outputs.
At any moment you can setup a screen as a Condence monitor clicking on the associated buon.