Datasheet

Data Sheet TMP05/TMP06
Rev. C | Page 9 of 28
PIN CONFIGURATION AND FUNCTION DESCRIPTIONS
OUT
1
FUNC
3
CONV/IN
2
V
DD
5
GND
4
TMP05/
TMP06
TOP VIEW
(Not to Scale)
03340-005
Figure 5. Pin Configuration
Table 5. Pin Function Descriptions
Pin No. Mnemonic Description
1 OUT Digital Output. Pulse-width modulated (PWM) output gives a square wave whose ratio of high-to-low period is
proportional to temperature.
2 CONV/IN
Digital Input. In continuously converting and one shot operating modes, a high, low, or float input determines the
temperature measurement rate. In daisy-chain operating mode, this pin is the input pin for the PWM signal from
the previous part on the daisy chain.
3 FUNC Digital Input. A high, low, or float input on this pin gives three different modes of operation. For details, see the
Operating Modes section.
4 GND Analog and Digital Ground.
5 V
DD
Positive Supply Voltage, 3.0 V to 5.5 V. Using a decoupling capacitor of 0.1 µF as close as possible to this pin is
strongly recommended.