Datasheet

TMP01
Rev. E | Page 5 of 20
ABSOLUTE MAXIMUM RATINGS
Table 3.
Parameter Rating
Maximum Supply Voltage −0.3 V to +15 V
Maximum Input Voltage (SET HIGH, SET LOW) −0.3 V to V+ +0.3 V
Maximum Output Current (VREF, VPTAT) 2 mA
Maximum Output Current (Open-Collector
Outputs)
50 mA
Maximum Output Voltage (Open-Collector
Outputs)
15 V
Operating Temperature Range −55°C to +150°C
Die Junction Temperature 150°C
Storage Temperature Range −65°C to +150°C
Lead Temperature (Soldering 60 sec) 300°C
Digital inputs and outputs are protected; however, permanent
damage may occur on unprotected units from high energy
electrostatic fields. Keep units in conductive foam or packaging
at all times until ready to use. Use proper antistatic handling
procedures.
Remove power before inserting or removing units from their
sockets.
Table 4.
Package Type θ
JA
θ
JC
Unit
8-Lead PDIP (N-8) 103
1
43 °C/W
8-Lead SOIC (R-8) 158
2
43 °C/W
8-Pin TO-99 Can (H-08) 150
1
18 °C/W
1
θ
JA
is specified for device in socket (worst-case conditions).
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
device reliability.
2
θ
JA
is specified for device mounted on PCB.
ESD CAUTION