Lite Board Evaluation System Manual

Connectors
2-16 ADSP-21364 EZ-KIT Lite Evaluation System Manual
Connectors
This section describes the connector functionality and provides informa-
tion about mating connectors. Figure 2-7 shows the connector locations.
Expansion Interface (J1–J3)
Three board-to-board connectors (J1–3) provide signals for most of the
processor’s peripheral interfaces. The connectors are located at the bottom
of the board. For more information about the interface, see “Expansion
Interface” on page 2-7. For the J1–3 availability and pricing, contact
Samtec.
Figure 2-7. Connector Locations